Even though the engine is vital to your car, the battery is what sends power to the starter, which starts the engine. Additionally, the battery powers all of the lights, the audio and navigation systems, computers, and other electrically-dependent components. if you want to have idea that how a car battery works read our previous article.
Reconditioning your car battery is crucial if you are experiencing problems with it holding a charge. There are workarounds for this issue that don't involve changing the battery. With just a minimal expenditure and a few tools, you can complete this at home.
Avoid ignoring battery problems in your car since they won't go away on their own unless you take action to remedy them.
Here are some steps car review magazine to fix a car battery that doesn't hold a charge.
1. Get the batteries ready. By placing a battery post cleaner on each battery post and rotating it back and forth until the posts are clean and bright, you may clean the batteries. The most efficient way to recharge a car battery is with distilled water and Epsom salt. Any sulfate buildup in your battery is removed when you add the Epsom salts and distilled water mixture.
don't forget to use safety glass that glows.
2. When reconditioning a car battery, you must drain all of the acids from the battery. There are six cells in an automotive battery, and they are filled with acid. After removing all of the acids from your automobile battery, prepare a distilled water and baking soda solution. Take approximately 250 grams of baking soda and 1 gallon of distilled water. Mix together baking soda and distilled water until completely dissolved. Fill each battery cell with a mixture of distilled water and baking soda. Attach the battery cell caps and vigorously shake the battery. You must now drain all of the mixes from the battery.
3. Examine the cells. Affix the voltmeter's positive probe to the positive battery post and place its negative probe inside the first cell. There is an issue with the cell if the meter does not show at least two volts for the cell. Place the negative probe in the second cell after placing the positive probe in the first cell. Place the negative probe in the third cell and the positive probe in the second cell. Continue doing this until every cell has been checked. Be sure to record the readings. The result should be 0 at the end.
4. Give a charge to the battery with a battery maintainer. The red (positive) and black (negative) connections are attached to the corresponding battery posts when the battery maintainer is first connected to a standard household outlet. The maintainer automatically switches on and supplies electricity for however long is required after it is linked to a home outlet and the car battery.